View single post by Nortonville Phil
 Posted: Sun Nov 12th, 2017 10:45 pm
PMQuoteReplyFull Topic
Nortonville Phil



Joined: Fri Dec 31st, 2010
Location: Red Oak, Texas USA
Posts: 88
Status: 
Offline
I have been talking to Stephen Fisher over the last week or so. Well I got interested in building something.  I found a scrap of pine lumber and ran it through a table saw and made some strip wood.  Then I knocked together a flat car underframe.  This is what I have so far.  I built this to 9mm scale to the foot.  So it represents 42 inch gauge on O guage track.  The couplers I am using are some of those old Walthers couplers that were made to be compatible with O guage 3 rail lionel type couplers.  These are actually smaller than Lionel and look better in my opinion. They are dummy couplers though so not good for switching.  The RR I am interested in used full size couplers on it's equipment.  That would be Japan and Taiwan. Well here are a couple of pictures.
DSCN3442 by Homewood Wheelman, on Flickr

DSCN3441 by Homewood Wheelman, on Flickr



____________________
Phil Randall
Trinity Valley Traction Co.

http://bluebonnetlimited.blogspot.com/

https://www.flickr.com/photos/73303708@N08/

DFW O Scale Modelers Club
Close Window