View single post by Si.
 Posted: Sat May 16th, 2015 03:13 pm
Full Topic
Si.



Joined: Thu Feb 23rd, 2012
Location: London
Posts: 5921
Status: 
Offline
There isn't an assembly-sequence given in the brief instruction sheet.
Ratio say, please check parts & fit before glueing !
No kidding !
I came to start glueing at 11:59pm & then thought better of it...
...I was gonna screw up FOR SURE !

I think it's well worth figuring out some kinda 'strategy' on the construction...
...or it's likely to come out a bit wonky !
Also, if you are unfortunate enough to glue some parts first...
...other parts them become impossible to get to.

It ain't rocket-science though...
...& I felt pretty cool about it in the morning; just not brain-dead at midnight !

:cool:



Putting all the pivots in first was good; kept it all lined up.
where the uprights join the base, there are no location-pips...
...& this should be glued last, for proper alignment...
...a bit of tape to hold it helps as well.

The pulley wheels need 1 flange glued on...
...a bit of tape helps here as well.

So far, so good ! :thumb:

Si.




____________________

' Mysterious Moose Mountain ' - 1:35n2 - pt.II
http://www.freerails.com/view_topic.php?id=7318&forum_id=17&page=1

' M:R:W Motor Speedway !!! ' - 1:32 Slotcar Racing Layout
http://www.slotforum.com/forums/index.php?showtopic=59295&st=0&a
Close Window