I have MRC Prodigy Epress system whose instructions I will call "book". I have MRC acces. decoder whose instructions I will call "sheet". Programming: Sheet says decoder is factory set to address 1. Sheet also says CV 513 main address to decoder is a 2 digit address. Book says programming: press prog until prog track, then press enter until cv appears then enter 513 then enter. Then enter address? What address? 1, or 2 digit or 515 ( which is first sub-decoder). Then book says selecting acces decoder: (am I still on prog track?) Press accesy and using 0-9 enter decoder address. What address?Sheet says "example" ( using slo motion machine which I have hooked up). To use output A (which is cv 515) program cv 515 to value of 0 or 128. Am I on program track? Is this a continuous program from above programming?
Is there anyone who has done this that can explain it in english? Clint
I am trying a second time to explain what is going on and seeking help. On the program track I go to "cv" and enter 513. Then I enter "1" (the decoder address), hit enter and the light flashes. I hit enter again to go out of programming. Then come back in and enter cv 515 (the first sub-decoder ). I enter 0 (because the instructions say to do this to control slo-motion machines) and when I hit enter, the light flashes. I now hook up to main track because I think I am done programming, but I can't get any response out of the decoder trying various things. The wires to the tortoise look correct including the resistors from the common to each "leg". I also tested the tortoise and it works fine. What am I missing? Clint