View single post by Daniel Osvaldo Caso
 Posted: Sun Sep 4th, 2011 12:05 pm
PMQuoteReplyFull Topic
Daniel Osvaldo Caso

 

Joined: Sun Aug 5th, 2007
Location: Amsterdam, Netherlands
Posts: 1617
Status: 
Offline
Lucas:

     It looks beautiful!!!

                              (It even made me feel a bit nostalgic)

    

     Did the parts come out so sharp or did you sand the edges? My experience at laser cutting 1mm thick styrene gave prety deformed edges even if it was black styrene which is said to give the less problems. The deforming was noticed more at the backside but at the front the engraved lines became a lot wither than when cutting MDF or wood.

                         Daniel

    



____________________
Extract from "THE FOUR STEPS METHOD" by Ching Pang Tsè:
1) Calm down.
2) Calm down.
3) Calm down.
4) First calm down.
Close Window